[cdn-nucl-l] Accurately determine contact surface stress distribution and magnitude!

[bebner@simlab.net]

Dear Engineer:

I am writing to inform you of a new product of ours - a sensor 
film that reveals the stress distribution and magnitude between 
any two surfaces that come in contact - by changing color. The 
intensity of the resultant color is quantifiable and enables you 
to determine precisely what the PSI is at any point on the 
contacting surfaces. This product is useful for assessing 
interfacial stresses that occur at gasketed and flanged 
interfaces, in lamination presses, roller systems and heat 
sealers, during welding, in materials testing and from impact 
forces. 

If you would like a FREE product sample and literature please let 
me know and I will be sure to send it out immediately. Please be 
sure to include an approximate PSI range that you want to 
experiment with for the application you have in mind. Pressurex is 
available in five sample ranges. Please choose one:

28 - 85 PSI 
70 - 350 PSI
350 - 1400 PSI
1400 - 7100 PSI
7100 - 18,500 PSI

Also be sure to include your contact information (address, phone, 
fax, etc.)

Thank you for your time.


Bill Ebner
Sensor Products Inc. 
188 Rt. 10 Ste. 307
E. Hanover, NJ 07936 USA

http://www.fuji-prescale.com

ph 973.560.9092
fx 973.884.1699



This message is sent in compliance with United States federal 
requirements for commercial email: Section 301, Paragraph 
(a)(2)(C) of s.1618. This email cannot be considered spam as long 
as it includes a removal method and contact information.

Further transmissions to you by the sender of this email may be 
stopped at no cost to you by sending a reply to this email address 
with the word "remove" in the text body area. All requests for 
removal will receive immediate attention.